PJ+

POWERJET MONOPLUG sequential injection is a new generation controller equipped with system that constantly monitors short and long term STFT, LTFT corrections and oxygen sensor POWERJET MONOPLUG OBD, with its version, easily communicates with all OBD II and EOBD auto systems (not only CAN) by OBD ADAPTER which aside from standard parameters enables the read out of your vehicle’s ECU corrections.

The technology applied in POWERJET MONOPLUG system assures the very precise fuel dosage and optimal fuel mixture injected into the cylinders. The contents of the mixture is configured not only based on the petrol injection timing as it is in other controllers, but it is precisely adopted to current petrol ECU corrections while driving on gas (not only during the calibration).

POWERJET MONOPLUG was created with accordance to plug’n’drive, user friendly technology, which makes it very simple to install and use. After the first calibration during the installation, POWERJET MONOPLUG self-adopts in real time during standard vehicle usage.

Moreover when installation of the system is made properly, POWERJET MONOPLUG system can be run even without calibration.

Advantages of POWERJET MONOPLUG :

Permanent, non interference connection with vehicles OBD, allowing connections of testers, diagnostic tools etc.

Minimizes the risk of defects associated with imprecise manual calibration.

Keeps the key engine settings such as power, torque identical to the petrol settings.

Fulfills the EURO 5 emission norms.

Optimizes the fuel consumption also in high RPM and high engine loads, and prevent the engine ECU from check engine mistakes like misfire, too rich or too lean mixture.